X
-
Greetings Luke,
New here, just minutes old I've not any experience with cast material, but MUCH with clays, both alone and with adjuncts like cone 6. Cracks are usually a thermo cycling issue and rather benign. Consider taking a measure on them and monitor. if they grow in length, chances are they'll also deepen (at some point). Should that happen sink a paperclip and get a depth. Lastly, do you know the cast material? Good to find out. Best of luck!
Leave a comment:
-
Are my cracks normal?
Hi all.
I have a pre cast oven.
I have finally got my temperature up to full temperature after around 13 progressively hotter curing days. 4 Cracks have appeared. I know that they aren't desirable and am gutted that I have them this early. I'm not sure if it is my fault or if they were just inevitable either way doesn't matter now.
What I would like to know is are they anything to worry about?
Is there anything I should do to stop them getting worse?
They shrink down to hair lines when cooling.
Mano ThanksTags: None
Leave a comment: