Announcement

Collapse

Forum Restore

If you’re a frequent visitor of the forum, you may have noticed that several new posts are missing from the past week. The team team was informed of an issue in the code and had to restore our forum to fix the issue. We thank you for continuing to be a part of the WFO community and enhancing the experiment of everyone in it.
See more
See less

Chimney support for dome oven

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Chimney support for dome oven

    I am mid build with my oven , which is a copy of Jamie Olivers brick oven apart from my dome
    will be rendered ,with the chimney going back over the dome and exit vertically at the centre of the oven
    my question was , as I have to support the stone mill wheel and brickwork that will sit over
    the dome centre , I would need to incorporate some level of support for this , giving the weight
    of the wheel and brick work this would im guessing have to be made of box section
    mild steel ? Has this been done before , my only concern would be and expansion
    of the steel , I did think to cover this by wrapping a little of the fire blanket on the
    exterior legs of any support to give it something the expand into rather than crack any render ,
    this support would be wrapped In chicken wire and rendered with the gap between render and oven being around 4
    this would be where the insulation blanket and vermiculite insulation would go
    I would appreciate any advice you could give me on this matter as I want to get it right first time ,

    Thanks ,jimmy

    Sent from iPhone
Working...
X