With this thread I will try to detail the construction of a portable pizza oven. This design is a straight knock off of The Brookencookies Satellite oven.
http://www.fornobravo.com/forum/f8/s...oven-4602.html
To start, I am using a 100 pound propane tank. This was available to me at no cost from a Craigslist add. It is a bit bigger than the tank BC had, but will end up about the same height, just a bit bigger around. This tank has a diameter of 15 inches.
As a heat source, I've bought in a cast iron burner from 'Bayou Classic' - found'm on the web. It burns propane. The burner is rated at 50,000 BTU.
These pictures show the tank as it was given to me. And after a bit of time cutting. I've cut the top off the tank, and will use this as the bottom of The Orb. And have cut a hole for the burner. I am using an angle grinder for most of the cutting, so straight cuts are easier than radius's.
I'll keep ya'll posted as this project progresses! It will be fun, and with luck, we can cook pizza on it when we are done...
JED
http://www.fornobravo.com/forum/f8/s...oven-4602.html
To start, I am using a 100 pound propane tank. This was available to me at no cost from a Craigslist add. It is a bit bigger than the tank BC had, but will end up about the same height, just a bit bigger around. This tank has a diameter of 15 inches.
As a heat source, I've bought in a cast iron burner from 'Bayou Classic' - found'm on the web. It burns propane. The burner is rated at 50,000 BTU.
These pictures show the tank as it was given to me. And after a bit of time cutting. I've cut the top off the tank, and will use this as the bottom of The Orb. And have cut a hole for the burner. I am using an angle grinder for most of the cutting, so straight cuts are easier than radius's.
I'll keep ya'll posted as this project progresses! It will be fun, and with luck, we can cook pizza on it when we are done...
JED
Comment