Re: 100 cm oven building in Romania
that was the first thing that popped into my head.....the corner or "point" in front of the oven. Definitely don't want that.
Announcement
Collapse
No announcement yet.
100 cm oven building in Romania
Collapse
X
-
Re: 100 cm oven building in Romania
That's a picture with the foundation frame. I used 10mm rebar for contour and wire mesh for inside. I placed the iron reinforcements 5 cm inside the margins and under the future surface of the foundation. I intend to cast it in 2 weeks when I'm back from holiday (Italy again ) where I'll do some more research.
Leave a comment:
-
Re: 100 cm oven building in Romania
Originally posted by byzonoo View PostI'll make the oven chamber 100 cm in diameter and I left 20 cm for the wall thickness.
Do you think that's enough?
Florin
Leave a comment:
-
Re: 100 cm oven building in Romania
Two things, I would not want that point in my chest when working the oven.
It may be that your image is to large to upload. You may need to use a lower resolution setting on your camera before taking them or use a program to lower the resolution. I find 1024x768 more than detailed enough for the purpose of this forum.
Leave a comment:
-
Re: 100 cm oven building in Romania
I aleady dug the hole for the foundation and made the rebar frame but I don't know why I can't upload the photo on the forum. ("upload failed" message)
Leave a comment:
-
Re: 100 cm oven building in Romania
I'm thinking a blanket and stucco. I'm open to any suggestions and advice, I don't know how it would be best.
Leave a comment:
-
Re: 100 cm oven building in Romania
Florin,
Are you going to insulate with a blanket or vermiculite? Also, covered with an enclosure or stucco?
Leave a comment:
-
100 cm oven building in Romania
So I decided to build my own WFO. As I mentioned I'm from Romania, there are not plenty of those around but I was in Italy a few times and I loved the taste of fresh "Pizza al forno legna".
Since the plans that I found on the net were for much bigger ovens than I needed, I decided to make my own plans according to my own needs and space available. I'll make the oven chamber 100 cm in diameter and I left 20 cm for the wall thickness.
Do you think that's enough? Any thoughts on the plans and the measurements? I can make some plans with imperial units too if needed.
FlorinTags: None
Leave a comment: