Second Large WFO in India

[1 strover]

Re: Second Large WFO in India

there is a lot happening in this picture, i made a steel reenforcement strap around the base we are tightening it here, increased a layer of bricks on the bottom, changed the pattern of the bricks for the base to a double brick herringbone doing this ment i had fewer smaller peaces around the edges.



a mock up of the arch



so i have a few more pictures to post form yesterday and today, believe it or not all this was done in one day.

[1 strover]

Re: Second Large WFO in India

today i have a few pictures to post, i was on holiday followed by a work trip to china to be followed by a holiday in another 2 days i only get back on the 15 th by when i shall have a functioning oven.
so here goes.


the stand with 4.5 inch calcium silicate board on it



my staff cutting the calcium silicate board to size



insulation cut and starting install



cutting bricks to size there has been a shit load of cutting to taper the bricks.



few more to post

[1 strover]

Re: Second Large WFO in India

so some more progress made today.
guess what i am welding?

[Laurentius]

Re: Second Large WFO in India

thanks a ton for the reply
will having them in the order i've listed increase heating mass ?(hold heat for longer?
as i also intend to bake around 100 1800 gm loaves of bread every morning.

Instead of the slab, I would increase my mass by laying my firebrick hearth on their side, rather than flat.

[1 strover]

Re: Second Large WFO in India

I think (4) is not needed. If you do use it, it should be number 3, followed by Calcium Silicate board, then fire bricks. But 7.5 CSB in more than enough.

thanks a ton for the reply
will having them in the order i've listed increase heating mass ?(hold heat for longer?
as i also intend to bake around 100 1800 gm loaves of bread every morning.

[Laurentius]

Re: Second Large WFO in India

I think (4) is not needed. If you do use it, it should be number 3, followed by Calcium Silicate board, then fire bricks. But 7.5 CSB in more than enough.

[1 strover]

Re: Second Large WFO in India

Gretings ,
i havent been post any updates as i havent made any progress till date due to the summer vacations we had over the past couple of months, this is the time when my restaurant is at its busiest. i have above 4000 guests eating every day. now we have entered the monsoon season here and now we have time to build.

i had a few questions which would make it clearer for me on how best to proceed.

in the meanwhile i have acquired
200 mm (7.75 in) thick calcium silicate board which i would use as floor insulation. i know it may be overkill
300 kg of EX-FOLIATED VERMICULITE
30 bags of castable concreete mix with VERMICULITE

My question is as follows
from the bottom up this is how i plan to layer the oven
1)mild steel stand which was made pictures of which are posted a couple posts above.
2)1.5mm galvanised steel sheet
3) calcium silicate board
4) castable slab 4 inches
5)fire bricks for the oven floor.

is my layering good or should i be layering this differently?

[1 strover]

Re: Second Large WFO in India

The chimney is way too small.

noted and size increased thanks

[Sparky005s]

Re: Second Large WFO in India

Any updates?

[1 strover]

Re: Second Large WFO in India

here are a few pictures
one is a heavy steel frame i made out of 12 gauge 2x4 box section.
in the second picture you see the frame and the last made out of wood for the dome. plan to keep the last in there till the mortar dries and then burn it in the oven itself.

[brickie in oz]

Re: Second Large WFO in India

the questions i have are
1) do i have too much insulation below the floor?
Ditch the glass and sand, they are not insulators.
2)should porosil alone be enough for insulating the dome?
It should be fine.
3)should i go barrel vaulted instead of an igloo style as i have already built one which is larger and has been in constant operational for the past year?
They both work fine, its your choice.

The chimney is way too small.

[1 strover]

Greetings,
My first build Large WFO in India
Now i am starting a second build.
The stats:
construction style :igloo
cooking floor dia :5 feet
internat dome hight :18 inches
dome material :fire bricks
cooking floor material: fire bricks/ soapstone( depends on availability)
insulation above dome : 24 inches porosil (EX-FOLIATED VERMICULITE)
insulation below floor from top to bottom: fire bricks 3 inches,crushed glass 3 inches,porosil and fine sand mix 5 inches, cement sheet 0.7 inches and finally 1mm of galvanized sheet metal.
chimney material :6 inch dia stainless steel pipe.

i just spoke to another supplier who can provide me with calcium silicate board should i use that for insulating the floor?
the questions i have are
1) do i have too much insulation below the floor?
2)should porosil alone be enough for insulating the dome?
3)should i go barrel vaulted instead of an igloo style as i have already built one which is larger and has been in constant operational for the past year?