100 cm oven build, Sweden

[Greenman]

Re: 100 cm oven build, Sweden

What is comfortable to lean on is a starting point. There are more considerations like the view of the fire for the guests and things like that. It comes down to personal preferences and not cooking 50 pizza at a session means that the physical operation of the oven is less important than the other things for me.

[ugnsnisse]

Re: 100 cm oven build, Sweden

Lit an imaginary fire yesterday, chipped of the wedges with a chisel and filled back the stone wall.

The oven floor is situated 140 cm above ground, and that is too high even for tall handsome men like me.

The plan all along has been to build a deck in front of the oven, until that is done I will fit a metal platform of 150x150cm directly on the massive rock that I unearthed below.

I'm thinking 110 cm from platform to oven floor, any other suggestions?

[ugnsnisse]

Re: 100 cm oven build, Sweden

Finally! I lost momentum for a while, especially since the mosquitos and sandflies made their entrance.

Since I've had no feedback on the buttressing I went without. To minimize the load the flue will be welded to a fitted metal sheet and fastened somehow to the arch with no more bricks.

All in all I'm really happy with the entry, the bricks have been cut on the visible side to make a nice clean impression.

[ugnsnisse]

Re: 100 cm oven build, Sweden

There's just so many knotts (sand flies) here that I can get no work done. Annoying!

[ugnsnisse]

Re: 100 cm oven build, Sweden

Finished the dome today. The final shape has a slight lean of the center towards front/side.
Skipped on the wedges a while ago. Just too much work compared to not using them.
To clean the joints in the top was extremely difficult from the stepladder I used, so there will be some brushing of the interior while firing to get rid of loose sand.

For entry I'm thinking a similar arch as the inner, that is, 3 bricks, then a brick cut 45? followed by the arch.
This will support a 100-150 cm SS flue pipe of 200 mm diameter. Some sort of base for the pipe will also be needed.

I see ovens built with buttressed archs and ovens that don't have them.
I'd rather not have any but if it's needed leave your opinion.

[ugnsnisse]

Re: 100 cm oven build, Sweden

Got use for a gymball for todays second and last course, the 9th I think. Also remembered to put a k-sensor in there.

[ugnsnisse]

Re: 100 cm oven build, Sweden

Continued on the 7th course with a mix of ? and ⅓ bricks. Looking at the pictures I can see that I have some wythes lining up somewhat. It have been complicated to keep track of all parameters at once.

[stonecutter]

Re: 100 cm oven build, Sweden

I am interest to see how the LECA ball work, at least from the 10,000 foot level they seem to be similar to Vermiculite or Perlite which are expanded shale rock. It would seem that the LECAs would have more compressive strength. IMHO. Out of the box thinking is good.

It's the primary insulation used by Neapolitan oven builders. You're correct about greater compressive strength.

[ugnsnisse]

Re: 100 cm oven build, Sweden

The arch-dome transitioning is working out nice. Next course will probably be the last before the gym-ball enters the dome. I will also cut the bricks in thirds for the remaining dome, or maybe I'll wait one more course.

Is it a good idea to mortar the joint between inner arch and landing/vent-arch?

[ugnsnisse]

Re: 100 cm oven build, Sweden

Got the 5th layer laid today, the towel in the pic is a try to keep the mortar from drying out in the sun.
Also got a new blade from ebay. This one is segmented and cuts so much faster than the smooth edged one.

[ugnsnisse]

Re: 100 cm oven build, Sweden

Getting on with the 4th course. Things are not lining up horizontally, I must start to think in 3 dimensions.
To have the pivot point 4 cm up from the bottom as my IT has isn't any good for anyone who tries to make a lower dome than it is wide.

[ugnsnisse]

Re: 100 cm oven build, Sweden

Torrential rain today, no good for mortaring.

[ugnsnisse]

Re: 100 cm oven build, Sweden

I am interest to see how the LECA ball work, at least from the 10,000 foot level they seem to be similar to Vermiculite or Perlite which are expanded shale rock. It would seem that the LECAs would have more compressive strength. IMHO. Out of the box thinking is good.

I think they will do fine, there's 10 cm of them so insulation should be up to standard and compressive strength is great, houses are built on top of blocks of these.

Today was rainy here so could'nt get too much work done.

Instead of wood wedges I'm using cut of pieces of brick that will stay there until it's all cured and then be cut of. (2nd pic)

I had a go with the angle grinder on the arch to smooth some edges out.

Will continue tomorrow.

[UtahBeehiver]

Re: 100 cm oven build, Sweden

I am interest to see how the LECA ball work, at least from the 10,000 foot level they seem to be similar to Vermiculite or Perlite which are expanded shale rock. It would seem that the LECAs would have more compressive strength. IMHO. Out of the box thinking is good.

[ugnsnisse]

Re: 100 cm oven build, Sweden

Hello,
LECA is short for Light Expanded Clay Aggregate, they are as the name says, light and made from expanded clay.
The hearth-bricks are "medium duty" yellow firebrick, the dome is low duty red firebrick, they come from an old chimney and some of them are really toasted but still intact and rock hard, so I have full confidence in them.