Announcement

Collapse
No announcement yet.

First loaves of bread

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ThisOldGarageNJ
    replied
    Re: First loaves of bread

    Looks just like what I buy at the bakery they call it swiss bread, It seems they call the same one with larger holes in it Italian loaves, I think it looks great, How did it taste ?

    Leave a comment:


  • Gromit
    replied
    Re: First loaves of bread

    OK, I am persistent if nothing else.

    Ye who have been commenting on this thread, please let me know what you think of the crumb on this latest effort. I have also re-posted last week's loaf for comparison.

    I made the following changes:

    1) I made this all in one day--no overnight retard.
    2) I tried to handle the dough minimally. (It seemed I was still squeezing every last bit of gas out of the fermented balls as I was shaping the boules.)
    3) I divided the dough into four 17 oz. loaves instead of three 23 oz. loaves. This was an accident. Because of this, I let the loaves proof an extra couple of hours to try to get them to fill the basket.

    I also put the loaves into an oven closer to 600 deg. than 500, so they burnt a bit on the bottom. I fed pizza to thirteen this evening and had been working on bread in one form or another from the moment I woke up, so I was ready to get these loaves in the oven and call it a day.

    Leave a comment:


  • CanuckJim
    replied
    Re: First loaves of bread

    Jay,

    Should have specified I used Caputo Tipo 00 Pizzeria flour in the formula.

    Jim

    Leave a comment:


  • texassourdough
    replied
    Re: First loaves of bread

    You have my attention! That is enough dough to really make sense and pull down the effort on large batches!

    I guess I know what I will ask Santa for!
    Jay

    Leave a comment:


  • CanuckJim
    replied
    Re: First loaves of bread

    Jay,

    The SP5 manual was translated from Italian, not very well either. One of the instructions is not to clean it when it's running. Nope, we are talking six pounds of flour here, not dough. I find if I go any higher than seven, though I could, it gets a bit messy until the flour is hydrated.

    Here's what I used for the pizza catering job:

    3035 gr/6.69 lbs flour
    1973 gr/4.35 lbs water (65%)
    6 gr IDY (7.5 if not being retarded overnight)
    24 gr/.86 oz sea salt (or a bit less according to taste)

    Result: twenty-four 210 gr dough balls for 10" pizzas

    The mixer didn't even blink.

    Jim

    Leave a comment:


  • texassourdough
    replied
    Re: First loaves of bread

    Hi Jim!

    You are a living advertisement!

    I am almost certain to get one. My wife will roll her eyes and I will have to figure out where to put it, but...I know I am going to increase my baking once I finish my dissertation! Thanks for the comments! We discussed the SP5 several years ago and I knew you loved it but your stories are getting better!

    There is one item I would like to verify. I had interpreted the capacity of the mixer as 8 pounds of dough and you seem to indicate it is 8 pounds of flour. I recognize that filling the mixer to the brim is at least messy, but that would imply a capacity for at least 13 pounds of dough! And your norm of 6 pounds of flour would equate to at least 10 pounds of dough. And...perhaps even more conveniently, it would easily take a full 5 pound bag of flour which is way more than a KA will handle.

    Being able to get up in the ten pound range is a big deal to me so, assuming I interpreted this right that makes the SP5 even more perfect!

    Look forward to your response.

    Thanks!
    Jay

    Leave a comment:


  • CanuckJim
    replied
    Re: First loaves of bread

    Jay,

    Can't recommend a spiral enough. I've had my counter-top Esmach SP5 for years. It's a horse. Very little maintenance (grease the chain every year or so). The friction factor is 26, as opposed to around 38 for a KA. The hook and bowl shape combination is simply awesome. The resulting dough is very well combined, silky, barely requiring hand kneading at all. I should get a commission from the San Francisco Baking Institute because of the number of people who have come here for courses, then immediately ordered one. One lady from Minnesota ordered hers by cell, standing in my kitchen. Google Santos, too. They have a counter-top fork mixer of about the same size. One of my course participants from New Zealand ordered one, and she's quite satisfied with it. Makes a lot of bagels for her teenagers.

    My mixer will hold 8 lbs of flour at a shot, but I usually restrict it to around 6 lbs to cut down the mess. There are, of course, larger models. Still, that's a lot of pizza balls. It's a heavy (deliberately) piece of gear. Doesn't walk around on the counter at all, even with enough dry bagel dough to make forty of them. We catered a wedding held on a property with a WFO (another student of ours). We made sixty dough balls in a few hours, retarded them overnight in the fridge in round containers and took them to the site in iced coolers. Made a lot of converts to Caputo and a WFO that night.

    I know these things are not cheap, but far as I'm concerned the mixer owes me exactly zip.

    Jim

    Leave a comment:


  • texassourdough
    replied
    Re: First loaves of bread

    Hi Mark!

    I don't worrty too much about humidity before loading. And it does take some time to load 15 pounds of boules and ciabatta and... so it is a concern, but...there is only so much you can do.

    As I think I stated, I clean the oven out - just rake and brush - when it is properly heat soaked. I do not mop it until the temp is ready to bake. The mop is only damp - not soaked, but it does hydrate the hearth somewhat. Then I spray the dome lightly to increase the humidity. Load like mad. Spray about five seconds (not on the bread and particularly in the back. Close the door. And relax. The panic is over. About 20 minutes in I take a look and move a few loaves around to make sure things are going right.

    I can't prove it makes a difference, but psychologically I really like to have some really wet ciabatta in the oven to serve as an extra source of humidity (usually around 3-4 pounds out of 15). It works for me and I enjoy the ciabatta! )
    Jay

    Leave a comment:


  • texassourdough
    replied
    Re: First loaves of bread

    Hi Dutch!

    Thanks for the comments re: loading. My only suggestion would be "LOTS of help" in the place of "a little help". I don't see how people get bread out of their ovens that are as pretty as they are (maybe photography is kind) when they only load a couple of loaves!

    I did some research yesterday. Doug had referred to his mixer as a spiral but it is technically a fork mixer. The videos I found online seem to show very similar dough texture and quality from both.

    Thanks!
    Jay

    Leave a comment:


  • Dutchoven
    replied
    Re: First loaves of bread

    Jay
    I wish I had a spiral mixer and the SP% is pretty great. We use a planetary type mixer but primarily to bring the dough together not really for development. I know what you mean about the kneading in small batches. In our home oven about 12-15 1.5# loaves was max...now in the restaurant oven that we are using to get used to the quirks of it it takes 20 just to make it a good load...depending on shape it can hold close to 30 if I hold my tongue right.
    Mark
    You have to do it as quickly as possible and then steam the oven manually after loading. As Jay mentions quite often the bread steams the oven while it is baking but in order for a great crust there has to be a load of steam...either a full oven load of dough or a little help. The ovens generally recover quite well.
    Best to all!
    Dutch

    Leave a comment:


  • MK1
    replied
    Re: First loaves of bread

    TexasS,
    How do you load 15 lbs at one time without losing your steam?

    Mark

    Leave a comment:


  • texassourdough
    replied
    Re: First loaves of bread

    Hi Dutch!

    I sit at the counter right by the fellow who forms the dough balls and last night the owner covered the spot for a while. I asked him about his new mixer and he handed me a ball and it was like nothing I have ever touched. Soft, velvety, extensible beyond compare, barely sticky, yet clearly wet. I had heard all the stories but I was not prepared for the real thing, i.e. the difference! The owner commented that they were in shock too by the difference it made.

    I knew about the gentleness. And I have heard the logic that the fork mixer is the best but that seems much more controversial than the advantage of the fork/spiral over elliptical.

    The crazy part was I thought I was making really neat dough by hand but... this was a real eye-opener.

    As I recall you have an SP5???? I think CanuckJim does too. I may have to order one - its been on my list for about two years. Mainly want it to do big enough batches to easily load my WFO to a good level for great crust w/o the hassle of hand kneading multiple batches.

    I am still shaking my head over the dough. It was sublime!
    Jay

    Leave a comment:


  • Dutchoven
    replied
    Re: First loaves of bread

    Jay
    What is great about the spirals, which you probably already know, is that they have a very low friction rate. Takes quite a while to overheat the dough. Only better mixer I suppose is the reciprocating arm type...
    Best
    Dutch

    Leave a comment:


  • texassourdough
    replied
    Re: First loaves of bread

    Good Morning David & Elizabeth (since we are the main dialoguers!)

    An interesting revelation last night that sort of relates to David's comment about his KA. Like David I have pretty given up mixers and go totally by hand and have had no regrets. Two weeks ago they guys my favorite pizzaria got a huge spiral mixer (went from 22 pound batches in a Hobart to "dump two [50 pound] bags of flour in and..." This was my first visit since the new mixer. The dough was amazing. Whole new texture profile I have never experienced. Like soft, wet, yet totally well behaved. I am in shock. I am going to have to go in on a Monday when they are making dough and watch this machine in action!

    I suspect I know how to approximate that quality by hand (or at least get closer) but...it was awesome!
    Jay

    Leave a comment:


  • Gromit
    replied
    Re: First loaves of bread

    Thank you all for the very helpful and interesting comments; I am learning a ton. Next time, I will skip the retard since that is about the only variable I have not played with.

    Elizabeth, cut those loaves open next time so I can see the inside! They look great, though. I would like to try shaping a batard some time soon. To answer your question, I have been doing all my mixing by hand. I discovered that I really despise my KA. I don't like the way it walks; I don't like the way it whines; I don't like the way that 1 lb. of flour does not seem to be big enough a batch for it yet 4 lbs is too big a batch; and I especially don't like the way it kicks flour all over the counter. It just seems easier and way more relaxing to mix dough by hand.

    Leave a comment:

Working...
X