If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Took me a little time to figure it out too. Actually, to be honest, every time I fire it up I learn something else.
I have done the "not hot enough" and the "too hot" where it was burning the crusts after about 10 seconds. I am also getting a better feel on when to add more wood to keep the temps stable and I found that splitting some thin pieces of wood, 2-3 inches thick and about a foot long, is a good size to just add every now and then. They burn faster and throw off heat quicker than the big, thick pieces of log, but obviously they don't last as long.
Took me a little time to figure it out too. Actually, to be honest, every time I fire it up I learn something else.
I have done the "not hot enough" and the "too hot" where it was burning the crusts after about 10 seconds. I am also getting a better feel on when to add more wood to keep the temps stable and I found that splitting some thin pieces of wood, 2-3 inches thick and about a foot long, is a good size to just add every now and then. They burn faster and throw off heat quicker than the big, thick pieces of log, but obviously they don't last as long.
Old Italian trick. Cast some semolina on to the centre of the floor after raking the coals aside and blowing the ash away. It turns black suddenly. 2 secs = too hot, 3 secs perfect, 4secs = not hot enough. It impresses guests too. It makes them think you know what you're doing.
Comment