Okay, try not to laugh too hard at the Sketch Up - I got it as straight as my nerves would allow. The capstones will be 4 inch block in real life - I just couldn't find a model of one and I used what I could find.
The house will be dry stacked for eventual dis-assembly. I'm not spending three hundred bucks for my dogs to eat plastic doghouses. The $30 or so every few months for toys rated as 'tough' which only survive a few months at best is bad enough.
I'm kinda stuck on the roof, though. I need to be able to take it off to do the periodic house keeping but it needs to stay on despite the dogs inevitable mangling (I figure I can recycle the block - the roof is pretty much a write off). The other problem is my extremely limited power tool access - I want to make as few cuts as possible and long angles on plywood are out of the question.
Any ideas?
The house will be dry stacked for eventual dis-assembly. I'm not spending three hundred bucks for my dogs to eat plastic doghouses. The $30 or so every few months for toys rated as 'tough' which only survive a few months at best is bad enough.
I'm kinda stuck on the roof, though. I need to be able to take it off to do the periodic house keeping but it needs to stay on despite the dogs inevitable mangling (I figure I can recycle the block - the roof is pretty much a write off). The other problem is my extremely limited power tool access - I want to make as few cuts as possible and long angles on plywood are out of the question.
Any ideas?
Comment