Temperature questions !!!!

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • david s
    replied
    Re: Temperature questions !!!!

    An infra red gun only reads the surface temperature. So higher readings may result if taken soon after moving coals or if flame is on the dome. If you let the flame die and waited 20 mins the temperature will even out and you would get a truer reading. Because of this problem they are not that useful, just keep firing and cooking and leave the IR gun, they can be confusing.

    Leave a comment:


  • jeeppiper
    replied
    Re: Temperature questions !!!!

    This is just a guess, but to me, it sounds like your insulation underneath your hearth might have some moisture in it. The moisture is taking the heat from your hearth bricks.

    Leave a comment:


  • Tscarborough
    replied
    Re: Temperature questions !!!!

    If you go by surface or air temps, you are not getting a real reading of the oven temp for a usable amount of time. To actually use the oven for more than a pizza or 4 you need to heat soak the brick, then ride the temp wave down, cooking the appropriate food at the temperature of the oven mass.

    Until the mass is heat soaked, the temp gradient will always be moving into the mass, cooling the surface in spots according to where the actual fire is.

    Leave a comment:


  • waltiti
    replied
    Re: Temperature questions !!!!

    Thanks @Tscarborough

    So both, the air in the dome and bottom firebricks surface of the oven where you place the food need to have around the same temperature...? Or the temperature chart you give me is for the dome and not the surface.


    I start the fire inside the dome in the right side normally and let heat up for almost 2 hs, after that I start to place the pizzas, sometimes other food like turnovers, sucking pigs, etc. but for the turnover and pig I only need around 500 deegrees;... my problem is with the Neopolitan, surface always have less temp ( around 200 deegrees) than the surface and the neopolitan sometimes have the edges and top cheese with some burns, but the bottom need more cooking time to be crsipy.

    Thanks for the help

    Leave a comment:


  • Tscarborough
    replied
    Re: Temperature questions !!!!

    Burn your fire long enough that the oven is heat soaked, and then it will be a consistent temp all over.

    Temp wise, here is a rough chart(temp/Style/Time to cook):

    850+ Neapolitan, 45-90 seconds
    700-750 NY Neapolitan/New Haven coal, 1-2 minutes
    600-700 New York Elite, 3-4 minutes
    550-600 New York slice, 4-6+ minutes
    450-550 American, 6-12 minutes

    Leave a comment:


  • waltiti
    started a topic Temperature questions !!!!

    Temperature questions !!!!

    Hi guys,

    I read a lot and at the end I really confused.

    I want to know how much need be the temperature of the oven for differents food, include pizza, but I need to know the temperature needed on inside the oven Air and the temperature of the surface ( fire bricks ).

    The reason is because depending where I do the fire, the surface get different temperature. Provably I do something wrong when I build the oven, that the reson of differents temperatures, I have the oven for a almost 2 years now, and I use it every weekend, the oven is inside, so the wind is not the problem.

    So, when the dome temperature get 700 - 800, I get the infrared gun and check it... If I start the fire on the right side, the surface get 500 - 550 , but if I start the oven on the left side, the surface gets 650 -700, almost the same as the dome air temperature. In the last case pizzas come so fast, an you can distract a second because get burned easy. And if i put the fire on the back, the front have a lower temp, like 200 degrees less in the front surface than in the right or left side of the oven.

    So guys, I will appreciate any advice on temperatures, to cook in the right way.
Working...