This is a bit of a continuation from dmun's thread, but I thought it was kind of a new topic. I purchased about 6-8 skids of firebrick which were originally purchased to build a smelting furnace for about .20 cents each. They are differing diameter of tapers and ratings of firebrick. The lowest rated are high duty, the highest is the 90%aluminum silicate 3000deg. white brick. These are not insulating, in fact the tapers weigh 11#each and are smaller than a normal brick. Anyway here are a few pics of the bricks laid out into oven configurations, what do you think?
P.S. The last photo spans 5' and the bricks are 6" thick, I set a normal sized firebrick in the photo for comparison.
P.S. The last photo spans 5' and the bricks are 6" thick, I set a normal sized firebrick in the photo for comparison.
Comment