Pouring Hearth Slab

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • rodeair
    Apprentice
    • Oct 2010
    • 163

    #1

    Pouring Hearth Slab

    I am ready to pour my hearth slab which will be about 6.5 x 7.5 feet. My question concerns the gaps around the plywood and small gaps between the form and a few of the block. Do I need to fill the gaps with something, or will the concrete stay out of the smaller gaps?
  • Paul in Rockwall TX
    Laborer
    • Nov 2010
    • 52

    #2
    Re: Pouring Hearth Slab

    depends on the size of the gaps and the size of the aggregate in the concrete mix. If it's peastone, the the gap should be smaller than that.

    Comment

    • dmun
      Il Pizzaiolo
      • Jul 2005
      • 4218

      #3
      Re: Pouring Hearth Slab

      Duct or masking tape will fill any voids. It may not be necessary, but it's impossible to fix once sludge starts running down the sides of your forms.
      My geodesic oven project: part 1, part 2

      Comment

      • rodeair
        Apprentice
        • Oct 2010
        • 163

        #4
        Re: Pouring Hearth Slab

        Thank you for the replies. I will use my favorite product in the world, (duct tape) to be safe. The concrete truck is due tomorrow morning so I'll post the results on my thread in the Pompeii Construction section. I very much respect both of you guys. Thanks again.

        Leigh

        Comment

        Working...