rust on reinforcing

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • hungng
    Peasant
    • Jun 2011
    • 25

    #1

    rust on reinforcing

    The wire reinforcing mesh I was going to use has lots of surface rust. Is it still ok to use? Should I try and clean it up a bit or use as is?
  • chidding
    Apprentice
    • Jan 2011
    • 176

    #2
    Re: rust on reinforcing

    THe alkaline environment of concrete stops the rusting, aswell as the lack of oxygen.. should be ok to use, most of the time, slightly rusted is easier than brand new/shiny/slippery reo.

    Comment

    • Tscarborough
      Il Pizzaiolo
      • Oct 2009
      • 3341

      #3
      Re: rust on reinforcing

      Unless it is scaling, surface rust is desirable for reinforcing steel.

      Comment

      • david lyons
        Serf
        • Nov 2010
        • 19

        #4
        Re: rust on reinforcing

        many years ago I put very rusty steel into a driveway slab, I was pretty broke and the reo I used was horrible rusty stuff, So much so I used to worry the slab would break up. About 7 years later I had to jackhammer it all out to allow for an extension. The slab was murder to break out, big compressor and heavy jackhammer, and the reinforcing came out looking like brand new steel, just an observation from direct experience.

        Dave Ly

        Comment

        • hungng
          Peasant
          • Jun 2011
          • 25

          #5
          Re: rust on reinforcing

          Thanks for the feedback.
          I'll certainly use it.

          Thank you.

          Comment

          Working...