Getting my barrel started!

[Greenman]

Re: Getting my barrel started!

Don't worry Dave, Beer cans also make a good plug for blocks since they crunch into the shape required and with some crumpled newspaper the 'plug' is complete.

I made sure that there was a good variety of beer bottles & cans plus some wine bottles in there just to show the 'finder' that the oven makers of the 2010's had an eclectic taste in and for alcohol. Plenty of junk mail is suitably preserved as well.

[cobblerdave]

Re: Getting my barrel started!

G'day
Mines just full of beer cartons and empties, whoever pulls it apart will probably think I'm a drunk
Regards dave

[Rotterdam]

Re: Getting my barrel started!

Great idea! I'll stuff a couple of things on top of my tape measure.

Rott

[Greenman]

Re: Getting my barrel started!

I filled all of the corners and then every second cavity. I also filled half of the top course of all of them to make a bond beam to hold everything together tight.

The holes in the alternate cavities make a good time capsule, I entombed some rolled up newspapers of the day, magazines, empty bottles of various things, aluminium drink cans and the like. Someone will demolish it one day and they will get to be amused or amazed or informed by the contents of my little time capsule I am sure.

[Rotterdam]

Re: Getting my barrel started!

Found my vermiculite source while visiting the in laws in Des Moines. 4 cubic feet of Ver $23. Perlite was only $19. Grabbed a
Bag of each to mix together! Menards had 3 cubic ft bags for
$17 FYI.

Also bought my brick saw from harbor freight. I looked extensively on eBay and Craigslist, however I struck out. For $220 I got a new saw and diamond blade after a online coupon. I thought about putting a blade in my table saw or my compound miter, but I didn't want to choke on dust. After the project is over I'll resell. Tested it on some block I had and it kicked butt!

[Rotterdam]

Re: Getting my barrel started!

Note to future builders. Don't leave your tape measure on top of the cinder blocks before they are filled. I went 5 courses high and bumped my favorite one in! After 30 mins of trying to retrieve it lays at the bottom of a 40" concrete grave. RIP my old friend.

On a side note did you other builders fill up every cinder block hole or did you skip every other? I went for them all.

[Rotterdam]

Re: Getting my barrel started!

Here is a pic with the blocks finished.

I'm planning on bending the rebar over to go through the center of the elevated pour. Mixing 10 cubic feet by hand will not be fun but the garden cart makes it super easy to do 160 lbs per batch. I also decided to buy a cheep awning, $50 from the walmart in Macomb IL. Feel free to chime in with advice at any time!

Rott

[Rotterdam]

After countless hours reading these forums and collecting materials I've decided to get going. Huge thanks to all who have come before me to collectively shape my build.

At this point my foundation and block is laid and I'm in the process of setting rebar and prepping for the elevated pour.