I got the soldiers mortared into place, and *thought* I was keeping things pretty clean on the inside. But, after fully curing/drying my homebrew mortar dries very bright white and is all over the place!. Even where I thought I cleaned things up with a wet sponge, there's still a thin layer of residue that dried & is visible.
Will these "white-washed" spots wear off after firing? Will water & scrub brush clean them off?
I'm ready to do the 2nd course, but figured I should perfect my technique a bit, if it's going to affect how the end result looks.
Thanks,
John.
Will these "white-washed" spots wear off after firing? Will water & scrub brush clean them off?
I'm ready to do the 2nd course, but figured I should perfect my technique a bit, if it's going to affect how the end result looks.
Thanks,
John.
Comment