Announcement

Collapse
No announcement yet.

Pizza Oven Build Question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pizza Oven Build Question

    OK, I decided to build a pizza oven this weekend. I poured my slab and got my first course of brick layed. After laying my brick I noticed I grabbed the 4WX8HX16L blocks. Will it be ok to use these blocks?

    I can add more rebar and wire mesh, any ideas?

    Thank you

  • #2
    Re: Pizza Oven Build Question

    That's a good question. I built an oven one time using a locally supplied narrow block (I don't have the exact dimension). I have to say that it was a little wobbly as it went up.

    If you want to go ahead with the 4" wide block, you can use bent rebar to tie your foundation slab, the block stand and the concrete hearth all together.

    What do other builders think?
    James
    Pizza Ovens
    Outdoor Fireplaces

    Comment


    • #3
      Re: Pizza Oven Build Question

      The rebar holes in four inch block are only about the width of a piece of rebar. There's no room to drystack and concrete fill the voids. If you're cool with mortaring your blocks, you should be OK. If you have no masonry experience, I'd stick with the dry-stack and fill plan.

      As for structural strength, it partly depends on what your exterior finish will be. If you plan a veneer of real 4 inch brick, that will stabilize things considerably. If your plan is for stucco, or a decorative veneer that depends on the stability of the underlayment, then, again why bother. The eight inch ones are only a fraction more expensive than the thin ones.

      Welcome. Good luck with your project.
      My geodesic oven project: part 1, part 2

      Comment


      • #4
        Re: Pizza Oven Build Question

        The holes in the block are about 4"x3" is this not enough space? I will attach a picture when I get home it will be better to see.

        I have rebar coming up out of the slab into the holes of the brick and I am planning on putting rebar across the top bent into the holes. My issue is that I have already laid the first course of block and the bigger pain would be reloading all the block to take it back etc.

        I will attach a pic. Thanks for the help!

        Comment


        • #5
          Re: Pizza Oven Build Question

          Sorry, when I got home I measured the bricks they are 6 inches wide. So will that be ok?

          -Sean

          Comment


          • #6
            Re: Pizza Oven Build Question

            I think the 6 inch wide blocks will be fine. They are recommended in the Sunset book "BBQs and Outdoor Kitchens". Eight inch blocks would be better and more stable, in my little mind, but I think you're OK. Use a bit more rebar to make up for it.
            GJBingham
            -----------------------------------
            Everyone makes mistakes. The trick is to make mistakes when nobody is looking.

            -

            Comment

            Working...
            X