Insulating layer finish

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • DimTex
    Apprentice
    • May 2009
    • 102

    #1

    Insulating layer finish

    I just finished pouring the portland and perlite layer and after the overnight set the surface looks, very spongy looking (like a dry sponge). Is this the way its supposed to finish out? Do I need to skim a thin layer of mortar or portland cement to "seal" and "stabilize" it? Will it support the weight of the floor and dome without compacting?
  • dmun
    Il Pizzaiolo
    • Jul 2005
    • 4218

    #2
    Re: Insulating layer finish

    Without fail, everyone who uses vermiculite concrete for the first time thinks it's weird and won't hold the weight. It will, if you followed the directions. Also, it needs a week to set up: vermiculite holds a LOT of water.
    My geodesic oven project: part 1, part 2

    Comment

    • 130mountainside
      Peasant
      • May 2008
      • 26

      #3
      Re: Insulating layer finish

      Thanks...its 24 hrs and it still seems spongy....wait a week before ripping it out?...haha

      Comment

      Working...