expansion joint?

[mpjfitz]

Hello

I've seen some examples (can't remember where!) of a gap between the inner dome and the cosmetic brick work. It sounds logical to have one I suppose.

Has anyone used one? what did you plug the gap with?

Any hints-tips will be appreciated

Mick

[dusty]

Re: expansion joint?

I think I understand your question.
Insulation goes on the outside of your oven bricks, then the cosmetic brick work. Lots of insulation. Then you can have a gap or not. I don't think it matters. The builders who used stucco to finish the top of the oven used no gap.
Hope this helps.

dusty

[mpjfitz]

Re: expansion joint?

Thanks for the reply ... maybe I should have explained my query better

I mean where the hearth and the chimney work meets the outer/cosmetic brickwork

Mick

[Les]

Re: expansion joint?

Mick,

I didn't use one, but when you mortar the brick, you almost get one by default. The mortar isn't going to be solid between the two bricks. I did separate the brick from the flue about two inches and filled the gap with vermiculite/portland for insulation.

Les...

[dmun]

Re: expansion joint?

I just put a piece of foil to create a slip joint there. You could use the flat stove door gasket material if you wanted to get fancy. There's also a quarter inch version of the insulating blanket, but I'm sure you'd have to buy the whole roll.