Re: Different method for a flat opening
This will work ok, I used this method for building a flat topped roof/door for a kiln, but remember that by drilling a hole through a brick you are weakening it and providing easier fracture.
Announcement
Collapse
No announcement yet.
Different method for a flat opening
Collapse
X
-
Re: Different method for a flat opening
Pretty cool! I don't see a problem with the approach. Should work just fine.
Leave a comment:
-
Different method for a flat opening
I wanted a flat opening for the oven, rather than an arch, simply for aesthetic reasons; but I didn't want a piece of angle iron showing as the support. I came up this this idea and it seemed to work pretty well.
I used a drill press and a masonry bit to drill through the bricks; the drill really easily especially with a drill press. I then used a piece of all thread as the support. I was originally going to use re-bar but I had an extra piece of all thread so I figured I would take it one step further and actually bolt it together.
Perhaps it is a terrible idea, I would love feedback.
You can see the rest of my oven here:
http://www.fornobravo.com/forum/f8/3...aks-16176.html
Best,
ChrisTags: None
Leave a comment: