If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Wow - several flavors of cal-sil as standard building materials. In the US, for commercial construction, we have duct board for restaurant grease ducts and elevator shafts and the like, and industrial/refractory applications. That's pretty neat!
They sell the AAC Hebel blocks, but they're not common here in the northeastern US. The Hebel US site doesn't mention the cal-sil panels/bricks at all.
curious what you are going to put on the Ytong walls. I wanted to do the same as you but when talking to Ytong (Xella in the Netherlands) they said they do not like it to be used outside. Ytong blocks degrade if they get wet for a long time. I now bumped into your thread and also seen the video you referenced when they were building a BBQ. All applications for outside...
Thanks for the info. After posting my question I realized that I had a somewhat different build in mind when I talked to the Ytong guys. I also wanted to use it to build "under ground". I would pour concrete below ground level and build upon that leaving me with my Ytong being partialy underground. That was something they did not like at all. Since they build complete houses out of Ytong you seem to be an a very good way.
I would suggest the middle of the arch; too close to the door and smoke might pour out the front; to close to the oven and potential for excessive heat loss may exist, though in reality that is one long arch and it probably wouldn't matter either way! Better get long-handled peels The little house turned out very well!
Comment