Forum Notice: The forum has been upgraded and restored to November 2. Posts and new accounts created after November 2 were lost. Sorry for the inconvenience.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Filling Cores of Concrete Block on the Front Course?
Filling Cores of Concrete Block on the Front Course?
Hello, Just in need of some advice on whether you fill the single course of blocks that sit on top of the angle iron? Can I just leave them hollow?
Thanks.
Re: Filling Cores of Concrete Block on the Front Course?
Originally posted by johnt
Hello, Just in need of some advice on whether you fill the single course of blocks that sit on top of the angle iron? Can I just leave them hollow?
Thanks.
It depends on your finish. I used tile so I had to fill them in order to have something the thin set could adhere to.
Comment