Oven Floor

[Les]

Re: Oven Floor

Thanks Uno! Did a quick search and saw that others have interchanged the two as well. This project is a learning experience - from many aspects.

JC - thanks for the lead in the Sac area. Don't need it now, driving across town is much easier

Les...

[Kemo]

Re: Oven Floor

nice attention to detail...looks great! how far back from the front of the stand is the oven opening? i had invisioned mine a bit closer to the front for ease of loading and unloading. Yours seems back a bit compared to some on the board. Thanks for posting the pics.

[Les]

Re: Oven Floor

Steve,

I had the same concern as well and this was discussed in some earlier posts. It was determined that having a landing area outweighs the reach problem. I am going to have a 12 inch landing in front of the entry. All said and done, it will be 29.5 inches to the inside of the oven ? seems like a lot. I took a 4 foot rod and was able to reach around inside fairly easy. Granted, that?s not fighting the small opening (12.5 x 20). I think with a 5 foot peel / brush it should be able to work. Not much I can do about it, this puppy isn?t going to slide forward very easy.

Les?

[Kemo]

Re: Oven Floor

Les,

regardless of where the oven is situated, im sure the pizza will taste just fine

[Acoma]

Re: Oven Floor

Les, what source do you use for both insoblock 19 and the Insulfrax blanket? Will you use Matrilite over the blanket/ fence wire, then finish with loose vermiculite?

[Les]

Re: Oven Floor

I'm going to use loose vermiculite over the blanket. It will be contained using stucco lath.

Les...