web analytics
Need help to continue SE MN insanity - Forno Bravo Forum: The Wood-Fired Oven Community



Dome Installation Video - Casa / Premio / Modena


For many of you who bought a modular oven, you may have asked how we put the domes together when we build them. For those of you considering one of our ovens, we shot a video to make your install easier.

Check it out on our You Tube Channel.


If the link doesn't work, simply go to You Tube and type Forno Bravo Channel. The video title is How to Set your Forno Bravo Oven Dome Pieces.

Thanks for participating in our Forum. We will have more video content available soon.
See more
See less

Need help to continue SE MN insanity

  • Filter
  • Time
  • Show
Clear All
new posts

  • Need help to continue SE MN insanity

    I need some positive reinforcement. I finished ( I hope) my insulating hearth, with is 2 inches of Asian FB board set onto an inch of perlcrete. The boards did, as told, absorb water from the perlcrete mixture. They were set in last Thursday...and today (Monday--5 days out) some parts of the boards are a little mushy, and I'm hesitant to start putting hundreds of pounds of bricks on them. Any advice? Wait a little longer to see if they dry out? Replace them?

    Thanks in advance,

  • #2
    Re: Need help to continue SE MN insanity

    Eric, I would avoid tossing on the tons of weight until they dry. I did do a test and the board survived - but I would not subject my build to it. Can you lift the boards to give them a bit of air? Where you live is not your friend in respect of humidity (until it is insane cold)...
    Check out my pictures here:

    If at first you don't succeed... Skydiving isn't for you.


    • #3
      Re: Need help to continue SE MN insanity

      Thanks Les,

      Yes, at 8 pounds a brick I'd be putting close to a ton on there, and at this point I can depress the FB boards 1/4 inch with finger pressure; so, this morning I dragged my basement dehumidifier up to the hearth enclosure and cranked it way down. Hopefully I can pull the water out of those boards by Sat AM, when I hope to set the soldiers. I can't lift them out without really destroying them, I think. They aren't soggy, just damp. We'll see, I may have to go with another plan.

      Thanks again,


      • #4
        Re: Need help to continue SE MN insanity

        Do the calculations as to actual loading and you will be surprised. Assuming a 36" firebrick dome and a 3000 pound load of firebrick, parging, etc, that gives you a floor loading of :

        38.25(center line of firebrick for a 36" diameter dome) * 3.1416 = 120.2 (circumference) x 4.5 (width of firebrick) =540.75 Square Inches of bearing surface, more or less.

        3000 / 540.75 = 5.54 pounds per square inch compressive weight on your substrate.

        Normal concrete has a compressive strength of around 3000 PSI and pink closed cell foam insulation is around 25 PSI so other than shrinkage issues as it dries, no worries.


        • #5
          Re: Need help to continue SE MN insanity

          Many thanks! Your calculation is no doubt closer than my "Fermi" calculation of 10 psi. Your result is even more encouraging. The boards seem to be drying out well, but for a while there they deformed quite a bit under finger pressure. I was worried I had ruined the binder matrix around the fibers, and that the construction would sink. The dry parts of the boards are much, much stiffer. I expect the whole board to shrink a small percentage after some good firings, but this should be constant for the whole structure, and hopefully I wont get any shifts with unwanted stresses.

          Again, thanks!