Ok, overall oven plan starting from slab is:
-Dual course brick stand(outer course conceals the inner course supporting base layers)
-Top slab 100mm reinforced concrete
- 100mm vermicrete
-Insulating board? Not 100% sure on this
-Oven floor 1100mm internal diameter. Finished floor level from ground (height) at present I'm thinking around 1100mm or 1200mm.
-floor and dome bricks will be 2nd hand fire bricks I got - 75mm x 110m x 225mm, obviously these will be angle cut in half for dome bricks and good fit
-Looking to thermally separate inner & outer dome arches
-Flue would be about 6 or 8 inches stainless steel, double skin where it passes through eave/roof
-Dome insulation with 1inch fire blanket and 4inches vermicrete, then render coat with waterproofing as exposed dome
......sure to make changes on the way

Leave a comment: