If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
actually I set the first piece in place, wife balanced it, placed second one held itself up at that point. placed third and fourth piece wiggled it around and it all came together. the first piece was the entry so it almost was balanced
Nice quality work. I am glad you decided to continue on the forum. Your work is topnotch and will help others who want to do a cast oven. Maybe you could do a picassa album show all of your steps. Have a nice holiday season.
I am very interested in building castable oven but my only concern is the performance issue if there is any. Have you had a chance to use yours? How is it holding temps, how long does it take to heat it up? Any info would be more then helpful.
thanks in an advance
I know this is an old thread but this mold is amazing. Im hoping Iron pony will respond. Im wondering (well Im wondering a lot of things about this casting but right no im wondering what the material is that was used to make the revel on the sections. I mean the thin piece is either luan or Masonite but Im wondering about the thicker piece attached to it. If any one knows I would greatly appreciate it. I believe this will be the mold system I use it seem perfect for my needs.
Thanks Tiggi I was so frustrated with this site after posting that I have not been back till now. I am ready to build the form its going to be a duplicate of Iron Pony's as far as I can tell its the perfect from. It would be great if you could share any changes you made to yours and if they were good decisions or not. You can just PM me for now I want to start a build thread but just cant do it today. Thanks for your reply on the revel.