Been thinking about the brick angle/bevel jig (see photos). Stole the design from Russel et. al. Anything else to consider in the jig design?
I labelled the plate, stop, and lever. Not sure if these are the right terms but… Seems like the side angle is determined by elevating (pivoting) the top plate and the bevel by moving the lever. Sound about right?
Russel mentioned in post #90 that “You really only need to cut the inner portion of the taper/bevel not the whole side of the brick for a tight inner fit.” I am not sure what that would look like in real life. Do I cut an inch in from the inner portion? 2 inches? Any photos out there of these limited cuts?
I labelled the plate, stop, and lever. Not sure if these are the right terms but… Seems like the side angle is determined by elevating (pivoting) the top plate and the bevel by moving the lever. Sound about right?
Russel mentioned in post #90 that “You really only need to cut the inner portion of the taper/bevel not the whole side of the brick for a tight inner fit.” I am not sure what that would look like in real life. Do I cut an inch in from the inner portion? 2 inches? Any photos out there of these limited cuts?
Comment