If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'll be 60 in June, so I guess I am, too. Of course, now that I'm older, the new old timers are in their 80's. Funny how it keeps shifting a decade as we get closer. My "old timers" comment was not directed at you. Hope you didn't take it that way. I have no clue as to your age. I was just fortunate when I was younger to work w/quite a few of older craftsmen and I learned alot. But, only because I paid attention and was a human sponge, soaking up as much knowledge as I could. Not just in masonry, but w/construction in general.
I'll be 60 in June, so I guess I am, too. Of course, now that I'm older, the new old timers are in their 80's. Funny how it keeps shifting a decade as we get closer. My "old timers" comment was not directed at you. Hope you didn't take it that way. I have no clue as to your age. I was just fortunate when I was younger to work w/quite a few of older craftsmen and I learned alot. But, only because I paid attention and was a human sponge, soaking up as much knowledge as I could. Not just in masonry, but w/construction in general.
Haha.... no lad, comments about my age don't bother me a bit. Likewise I have been fortunate to grow up and work around a solid group, many of which I think of as masters of their craft. That is what I strive for too...assurance of my ability within my chosen field.
G'day
On your path to making your oven resistant to the elements you might seriously consider a waterproof door/cover at the entrance to the oven. The outer entrance so the entrance hearth is protected. Once rained on the water quickly wicks into the insulation.
Your never going to stop tithe bricks naturally taking up water from the air but that nothing really that a few good fires will sort out.
Regards dave
Measure twice
Cut once
Fit in position with largest hammer
Can I use any paint on this oven? Or does it need to be special. I bought masonary paint. Which I assume is fine ontop of render stucco.
G'day
That's great, that's what is made for. Manufacturers instructions usually say to leave it for a while for fresh cement and brick which is not a bad thing as the oven will contain a certain amount of moisture for a while yet.
Regards Dave
Measure twice
Cut once
Fit in position with largest hammer
Getting back to this, I am always mystified why the young tradies don't take advantage of the old farts, tradesmen, craftsmen and their exquisite skills that took often 40 to 50 years to develop.
I have experienced on numerous occasions where old tradies take all their skills to the grave just because family members and fellow workers aren't interested in their skills which are the lost often forever, as they will not be found in books but only handed on by word of mouth.
I love spending time with old craftspeople, showing genuine interest, asking questions and discussing alternatives, often with incredible responses from them.
Neill
Prevention is better than cure, - do it right the first time!
The more I learn, the more I realise how little I know
Getting back to this, I am always mystified why the young tradies don't take advantage of the old farts, tradesmen, craftsmen and their exquisite skills that took often 40 to 50 years to develop.
I have experienced on numerous occasions where old tradies take all their skills to the grave just because family members and fellow workers aren't interested in their skills which are the lost often forever, as they will not be found in books but only handed on by word of mouth.
I love spending time with old craftspeople, showing genuine interest, asking questions and discussing alternatives, often with incredible responses from them.
Neill
That's a conundrum. And what you say is partially true. However....
The problem is not always about the young tradesmans lack of effort. Sometimes, there are more experienced guys that are unwilling to teach. There are older tradesman stuck in their ways, unwilling to change with the times, or adapt their techniques to modern construction. When those that have the " I've done it this way for 30 years so don't question me", attitude...all they do is perpetuate a stuck in the mud, one dimensional view. And there are an awful lot of those types.
I have worked with a lot of old tradesman, and like I mentioned earlier, a few of I would consider them to be Master Craftsman. A common trait a TRUE master possesses, is the desire to teach, and yet they can still learn and apply new techniques and methods. And, it's not simply because they want to pass on exactly what they know or how they do things to another...it's because they care about the bigger picture, which is preserving quality.
Comment