We notice all Forno Bravo drawings place the oven flush with the front of the metal stand, leaving approximately 8" of clearance at the back. Is there any reason for this? The finished sides of the oven leave almost no clearance. We would like to place our oven at the back of the stand and use that extra 8" at the front for a landing. We can't see any reason why this would be a bad idea. Is there any reason not to do this?
I should add that we bought the propane version so that we could retrofit it with propane at a later date. We understand that if we push the oven towards the back of the stand, we'll need to re-drill the brackets for the propane assembly, drill a new hole in the backer board, and plug the predrilled hole in the backer board before pouring the concrete hearth.
Thanks!
H&H
I should add that we bought the propane version so that we could retrofit it with propane at a later date. We understand that if we push the oven towards the back of the stand, we'll need to re-drill the brackets for the propane assembly, drill a new hole in the backer board, and plug the predrilled hole in the backer board before pouring the concrete hearth.
Thanks!
H&H
Comment