Announcement

Collapse
No announcement yet.

Floor sanding?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Floor sanding?

    Hi,

    My oven is moving forward nicely I am on the fourth course need to post pictures but I am building a 36" oven and tapering all of the bricks. Had a problem right off the bat with the HF saw as it wouldn't spin up fast enough to disengage the motor brake. Fixed that by removing a spring from the motor brake.

    Anyway, my question is on the floor. I have been trying to smooth it out using the brick and belt sander technique. So far I have gone through a lot of belts as they seem to tear easily and have a relatively rough surface. Does it matter if the brick is rough as long as it is even? Any suggestions for making it smooth?


    Thanks


    Julian

  • #2
    Re: Floor sanding?

    Julian.

    I used 40 grit from lowes - they have 2 flavors and either one of them sanded pretty well. They do wear out fairly quick. I think if you get the edges removed you will be good to go.

    Les...
    Check out my pictures here:
    http://www.fornobravo.com/forum/f8/les-build-4207.html

    If at first you don't succeed... Skydiving isn't for you.

    Comment


    • #3
      Re: Floor sanding?

      Hi Julian,
      I experienced the same problem and used a special grinding disk on my angle grinder (or 7" 2 speed buff).
      See the details on: http://www.fornobravo.com/forum/f21/...-4-a-2045.html

      permalinh #8.
      Sand your floor BEFORE you close the dome for accessability and if you don't you won't be able to see what you are doing. Also the abrasive dust going through your grinder motor will stuff it up in no time.

      Neill
      Prevention is better than cure, - do it right the first time!

      The more I learn, the more I realise how little I know


      Neill’s Pompeiii #1
      http://www.fornobravo.com/forum/f8/n...-1-a-2005.html
      Neill’s kitchen underway
      http://www.fornobravo.com/forum/f35/...rway-4591.html

      Comment


      • #4
        Re: Floor sanding?

        Um, from the peanut gallery. If the floor is rough any dough will stick to it.
        "He is no fool who gives what he cannot keep to gain what he cannot lose." - Jim Elliot

        "Success isn't permanent and failure isn't fatal." -Mike Ditka
        [/CENTER]

        Comment

        Working...
        X