Tweet
Hey All,
This past weekend I continued my goofing off from actual work on the oven and finished a Flash application I started over the holidays that will allow folk to take a virtual tour of the oven progress to date via a series of spherical panoramas (works with Flash v 8 & 9).
It is located at:
OvenCamHiRes
James, I looked for a way to load this on the FBsite but couldn?t find it, so put it on my site (with appropriate credit and link to the FB community in the floor of both the dome and arch).
The application will allow visitors to look at every inch and flaw in the dome, arch and front area of the oven. You will be able pan left, right, up, down, zoom in/out to determine when I switched from a brush to a sponge for clean up, when I ran out of refmix and had to switch to refrax , where I got impatient with partials and when I finally started taking the ?if it?s not going to be seen don?t spend time on it? advice from the instructions.
To view, once the application comes up and the panorama has loaded, hold down the left mouse button and drag the mouse in the direction you want to view (up down left right arrows also work). Along the way you will run across faded red arrows. Mousing over these arrows will display a caption of the next area of the tour, clicking on the arrow will take you to the area in the caption. There is a help button in the lower right of the appliance if you have problems.
if the motion is jumpy at the above URL try the low res version at:
OvenCamLoRes
I will be adding a slide show and a 360 of the outside of the oven once the weather breaks and I can move the tent. In the meantime if you have any suggestions or run into any problems, drop me a note.
Thanks once again for all the support that has gotten me this far.
Jim
This past weekend I continued my goofing off from actual work on the oven and finished a Flash application I started over the holidays that will allow folk to take a virtual tour of the oven progress to date via a series of spherical panoramas (works with Flash v 8 & 9).
It is located at:
OvenCamHiRes
James, I looked for a way to load this on the FBsite but couldn?t find it, so put it on my site (with appropriate credit and link to the FB community in the floor of both the dome and arch).
The application will allow visitors to look at every inch and flaw in the dome, arch and front area of the oven. You will be able pan left, right, up, down, zoom in/out to determine when I switched from a brush to a sponge for clean up, when I ran out of refmix and had to switch to refrax , where I got impatient with partials and when I finally started taking the ?if it?s not going to be seen don?t spend time on it? advice from the instructions.
To view, once the application comes up and the panorama has loaded, hold down the left mouse button and drag the mouse in the direction you want to view (up down left right arrows also work). Along the way you will run across faded red arrows. Mousing over these arrows will display a caption of the next area of the tour, clicking on the arrow will take you to the area in the caption. There is a help button in the lower right of the appliance if you have problems.
if the motion is jumpy at the above URL try the low res version at:
OvenCamLoRes
I will be adding a slide show and a 360 of the outside of the oven once the weather breaks and I can move the tent. In the meantime if you have any suggestions or run into any problems, drop me a note.
Thanks once again for all the support that has gotten me this far.
Jim
Comment