Dome wall thickness question

[olddude]

Re: Dome wall thickness question

okay how about this one

[olddude]

Re: Dome wall thickness question

might help with the drawing lol

[olddude]

Re: Dome wall thickness question

if you build and opening like this the vent will work

[dmun]

Re: Dome wall thickness question

I'm afraid I don't understand this drawing. Is the vent in the oven chamber?

[fxpose]

Re: Dome wall thickness question

I'm afraid I don't understand this drawing. Is the vent in the oven chamber?

That's olddude's drawing. I don't think the square lines drawn inside the chamber are part of the vent.

[Neil2]

Re: Dome wall thickness question

"As far as the shallow entry goes, it will be rectangular with a flared side wall opening. "

This is what I built and I am glad I did. It is a little trickier to make but you get much improved visibility and accessibility into the oven. Another benefit is that you can design a door with "wings" the same angle as the flare. This makes the door easier to place, makes a better seal and is freestanding without a base or struts.

[olddude]

Re: Dome wall thickness question

dmun this is what i was thinking that might work for his requirements

[fxpose]

Re: Dome wall thickness question

Thanks again, olddude.
I realize I don't have much latitude trying to build the largest oven I can fit within a 48" circle, especially placement and design of vent/entry. But I think got it figured out and your cad drawing pretty much nails it.

[dmun]

Re: Dome wall thickness question

Yes, that makes more sense. It is possible to squeeze your oven opening into the insulation circle, but it makes it more difficult. I did pretty much the same thing, and ended building part of my flue support on the top of my dome.

It's really easier if you give yourself a little more room to work.

[olddude]

Re: Dome wall thickness question

no problem i like trying to solve puzzles on cad need any dimention
worked out let me know i have that drawing saved.

[fxpose]

Re: Dome wall thickness question

"As far as the shallow entry goes, it will be rectangular with a flared side wall opening. "

This is what I built and I am glad I did. It is a little trickier to make but you get much improved visibility and accessibility into the oven.

Those were exactly the two reasons for the flared opening.
Also, the fire in the chamber can be seen from a wider area.

[fxpose]

Re: Dome wall thickness question

I decided to go with the 3" wall thickness to maximize floor space. Starting from the 4th course up I can and might go with 4.5" bricks, as there will enough clearance from that course on upward.

I started erecting the dome yesterday: