Some of the builders 20-25 years ago recommended the addition of foil layer between the refractory material and the outside (insulating) cladding. This was to provide slip between layers during the expansion/contraction of the oven chamber during use. As David S above noted, using foil between the hearth and floor insulation doesn't make any sense. Using it between the concrete stand and the bottom of the insulation layer might inhibit water from wicking up into the insulation but wouldn't be your best option. There were also recommendations 20-25 years ago of using diatomaceous earth to provide this slip layer...its supposed advantage was that it would fill minor cracks that formed during expansion and could be applied a bit more thickly...
I actually used the diatomaceous earth method as a slip layer between my oven brick and the outer top layer of insulating perlcrete for my oven. I had it on hand and didn't spend a lot of time on the forum investigating or asking the question of "Is it worth it?" before starting my build
. I don't think it made any difference and it certainly was a pain in the a__ to apply. 
I actually used the diatomaceous earth method as a slip layer between my oven brick and the outer top layer of insulating perlcrete for my oven. I had it on hand and didn't spend a lot of time on the forum investigating or asking the question of "Is it worth it?" before starting my build
. I don't think it made any difference and it certainly was a pain in the a__ to apply. 





Comment