2024 Neapolitan oven build

[daidensacha]

atak Good luck with your build. Hope you enjoy it and it performs how you want it to. Its far removed from the forno bravo build, which I chose and couldn’t be happier with.

Can’t comment more other than to say that refractory bricks for me are superior to clay bricks when it comes to thermal cycling and longevity. Also the performance with regards to conduction and heat retention is superior. Depends what you want, and how long you want it to last.

I built a small wall in my garden 9 years ago using recycled clay bricks. They are flaking from exposure to the variance in temperature here in Bavaria. I wouldn’t want that in my oven.

[atak]

Hello,I donot mean the clay bricks but the way they are cementing without special cutting machines. You made a piece of art and they donot care as long as it works I suppose.

[daidensacha]

Final layer of render on dome

This last week I have been working on finishing the final layer of render on the dome. I incorporated nylon mesh where the dome render meets the base and the front chimney structure to reduce any cracking if there is movement. At last, a bit over a year after starting the oven the rendering is done. With the warm weather expected this week I should be able to paint it in about a week. Then I‘ll refit the Ash slab on the bar at the rear of the preparation bench top. FInishing the details is really fulfilling.

[daidensacha]

Adding reinforcing mesh to render

[daidensacha]

Matching oak bench seats for oak table

This week I also planned down some oak slabs and built to matching oak benches to go with the oak table. The oak is well seasoned, 13 years since it was cut. I have started filling cracks and blemishes with 2 part epoxy colored with black iron oxide. Its a tedious process, as I need to wait 24 hours after filling before being able to sand it flat, then move to a different side. Once the filling and sanding is finished, I can oil it.

I really like how adding the black epoxy not only fills blemishes, but also highlights and makes a feature of them. I‘ll put some more pictures when it is done.

The bench tops are 3300mm x 400mm x 40mm. I kept the natural sides, only removing the bark and sanding to smooth the edges.

[Toiletman]

Wonderful work again, great to see it all come together even the finishing touches!

[daidensacha]

Oven painted, light switch fitted

The last days I fully painted the oven, giving it 3 coats of off white. Added mission green skirting and waist band. Waiting on a stencil which I will use to add a nice pattern around the oven on the green band.

Waiting on some more 2 part epoxy resin so I can finish off the bar, oil it and screw it down on the back of the bench. Then I can finally clean off the pizza bench and put it to the work its intended for.