Tools, Tips and Techniques

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Topics	Statistics	Last Post
Sticky: Concrete by the wheelbarrow, mixer, trailer or pump by james Started by james, 12-04-2006, 03:14 PM	67 responses 70,812 views 0 likes	Last Post by Gulf 03-29-2024, 07:40 PM
Sticky: Dome spreadsheet calculator by deejayoh Started by deejayoh, 07-26-2012, 03:37 PM	115 responses 46,252 views 3 likes	Last Post by Macrinehart 03-04-2023, 03:20 PM
Sticky: Hendo's dome gauge -- nice idea by Hendo Started by Hendo, 08-13-2007, 07:08 AM	33 responses 42,536 views 1 like	Last Post by mirassou 04-23-2022, 01:43 PM
Sticky: Official - Show off your tools. by V-wiz Started by V-wiz, 03-28-2013, 09:35 PM	99 responses 14,017 views 0 likes	Last Post by UtahBeehiver 03-23-2020, 06:37 AM
Sticky: Safety Issues by james Started by james, 06-17-2007, 02:56 AM	98 responses 23,701 views 1 like	Last Post by Guest 12-11-2014, 04:34 PM
New blast door. by brickie in oz Started by brickie in oz, 10-01-2011, 08:21 PM	14 responses 2,797 views 0 likes	Last Post by mrchipster 10-07-2011, 08:43 PM
Why does home brew need to cure? by mrchipster Started by mrchipster, 09-27-2011, 02:34 PM	27 responses 5,040 views 0 likes	Last Post by Guest 10-06-2011, 01:17 PM
Low alumina content firebricks - are these ok? by BrickOvenMike Started by BrickOvenMike, 09-29-2009, 01:48 PM	11 responses 2,457 views 0 likes	Last Post by old wanderer 10-02-2011, 09:00 PM
outer dome construction by edsalldw Started by edsalldw, 09-29-2011, 12:20 AM	3 responses 1,293 views 0 likes	Last Post by stwater 09-30-2011, 04:58 AM
Extensive cracks inside dome of Forno Bravo Primavera oven by esko79 Started by esko79, 07-16-2011, 10:56 AM	4 responses 2,993 views 0 likes	Last Post by scottz 09-26-2011, 03:17 AM
advice on cladding masonry dome by afrompa Started by afrompa, 08-25-2011, 12:59 PM	5 responses 2,030 views 0 likes	Last Post by Ken524 09-22-2011, 08:18 AM
Importance of Stand size by gtofani Started by gtofani, 09-08-2011, 09:56 AM	7 responses 1,509 views 0 likes	Last Post by gtofani 09-16-2011, 05:41 PM
mortar mix.. by The Darling Dome Started by The Darling Dome, 09-14-2011, 03:16 PM	4 responses 1,548 views 0 likes	Last Post by The Darling Dome 09-15-2011, 06:50 PM
firebrick 'dust, sludge' reuse? by victorsee Started by victorsee, 09-09-2011, 08:15 AM	5 responses 2,229 views 0 likes	Last Post by victorsee 09-15-2011, 06:45 AM
Electricity generated from a WFO. by sonomacast Started by sonomacast, 09-02-2011, 01:32 PM	5 responses 1,278 views 0 likes	Last Post by Neil2 09-09-2011, 05:34 PM
fire rock mortar by MAVANO Started by MAVANO, 09-04-2011, 09:30 AM	4 responses 3,602 views 0 likes	Last Post by MAVANO 09-06-2011, 06:06 PM
Fire Clay by Hank10746 Started by Hank10746, 08-30-2011, 08:38 PM	5 responses 2,360 views 0 likes	Last Post by Hank10746 09-03-2011, 04:00 PM
Fiberglass Insulation for Dome by BakerBoy Started by BakerBoy, 09-02-2011, 08:28 PM	1 response 4,107 views 0 likes	Last Post by david s 09-02-2011, 09:37 PM
time to allow a set of bricks to set by s988rt Started by s988rt, 08-31-2011, 04:32 PM	5 responses 1,391 views 0 likes	Last Post by GianniFocaccia 09-01-2011, 02:19 PM
poured castable refractory oven floor? by larrycooper Started by larrycooper, 08-28-2011, 05:18 PM	6 responses 4,894 views 0 likes	Last Post by sonomacast 08-30-2011, 12:52 PM
hearth Insulation question by sonomacast Started by sonomacast, 08-25-2011, 08:46 AM	5 responses 1,606 views 0 likes	Last Post by sonomacast 08-26-2011, 11:17 AM
So will there be a discourse on tapering bricks? by skoolpsyk Started by skoolpsyk, 11-13-2008, 07:07 AM	8 responses 5,251 views 0 likes	Last Post by SCChris 08-22-2011, 05:28 PM
Harbor Freight SAW SALE by Hank10746 Started by Hank10746, 08-14-2011, 12:01 PM	0 responses 1,508 views 0 likes	Last Post by Hank10746 08-14-2011, 12:01 PM
Thermal Break Materials by BothellOven Started by BothellOven, 08-07-2011, 12:58 PM	10 responses 3,085 views 0 likes	Last Post by gmchm 08-12-2011, 05:30 PM
Indoor installation in Canada by Ottawa_sd Started by Ottawa_sd, 08-11-2011, 09:38 AM	1 response 1,700 views 0 likes	Last Post by CanuckJim 08-12-2011, 01:17 PM

Previous 1 16 23 24 25 26 27 28 29 36 57 template Next

No topics found.

Mark This Channel Read

Working...

Announcement